Electrolux FAC124P1A Instrukcje Operacyjne Strona 89

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 88
Section 4 Component Teardown
4-29
Model FAK ( Slider/Casement) Series
Filter And Front Panel Assembly Removal
1. Disconnect the power supply from unit.
2. Grab filter handle at top center of the front grille.
Pull out, then upwards to remove filter.
3. Extract the four screws securing the front panel to
the cabinet wrapper/sleeve. (See Figure 4-73)
4. Using a putty knife, carefully pry out the side and
top retaining clips from the slots cut in the cabinet
wrapper. (See Figure 4-73, Arrows show tab
locations)
5. Pull front panel carefully from front of unit until
the user interface connection can be accessed.
Disconnect user interface from wire harness. Front
panel is now free from unit.
Cabinet Wrapper/Sleeve Removal
To remove the cabinet wrapper/sleeve:
1. Disconnect the power supply from unit.
2. Remove the front panel assembly.
3. Extract the screws from each side of unit. Extract
the screws securing the cabinet wrapper/sleeve to
the back of the unit. (See Figure 4-74)
4. Lift the cabinet wrapper/sleeve off of the unit.
User Interface Removal
To remove the user interface:
1. Disconnect power supply from unit.
2. Remove the front panel assembly.
3. Extract the six screws securing user interface to front
panel then lift user interface off front panel.
(See Figure 4-75)
Closed
Open
Exhaust
Figure 4-73.
Pull Out
Filter
Screws
Screws
Rear View
Side View
Screws
Figure 4-74.
Due to the number of models within the series, some
teardown procedures, such as locations and number of
fasteners, and location of electrical system components,
may vary from the descriptions given in this section.
Always use the wiring diagram attached to the unit for
all electrical connections.
NOTE
Figure 4-75.
Screws
Przeglądanie stron 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 139 140

Komentarze do niniejszej Instrukcji

Brak uwag