Electrolux FAC124P1A Instrukcje Operacyjne Pobierz pdf (Strona 70)

Section 4 Component Teardown

4-10

Removing the Condenser Fan and Blower

Assembly

The condenser fan and blower assembly consists of

the blower wheel, condenser fan and shroud, front and

rear blower housing and right bulkhead partition. The

assembly is secured with screws to the evaporator,

condenser and the unit base.

To remove the condenser fan and blower assembly:

1. Disconnect power supply from unit.

2. Remove the front panel assembly. Pull the unit from

the cabinet wrapper/sleeve.

3. Remove the front scroll cover. The wire leads from

the compressor, condenser fan and capacitor must

be disconnected from the control box components.

The control box must then be removed from the

unit.

4. Remove the capacitor cover. Disconnect wire leads

and remove from unit.

5. Cut wire retainers, then route the wire harness leads

so that the condenser fan assembly can be pulled

straight up out from the unit base.

6. Remove condenser fan cover.

7. Extract the two screws from each side securing the

fan assembly to the condenser assembly.

(See Figure 4-20)

8. Extract the two screws from the lower right side

securing the right bulkhead partition to the unit

base. (See Figure 4-20)

9. Extract the two screws from the right front securing

the right bulkhead partition to the evaporator.

(See Figure 4-21)

10. Extract the two screws from the left side securing

the right bulkhead partition to the unit base and the

evaporator.

11. Extract the two screws under the condenser fan

motor securing the assembly to the unit base.

(See Figure 4-20)

12. Pull condenser fan assembly straight up out from the

unit base.

Figure 4-20.

Figure 4-21.

Screws

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 139 140

Komentarze do niniejszej Instrukcji

Brak uwag

Electrolux FAC124P1A Instrukcje Operacyjne Strona 70

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Electrolux FAC124P1A