
Section 4 Component Teardown
4-17
Thermistor Removal
There are three thermistors on units equipped with a
heating element.
To remove the ambient thermistor:
1. Disconnect power supply from unit.
2. Remove cabinet wrapper/sleeve then remove control
box cover.
3. Disconnect thermistor wire leads at control board.
4. Pull thermistor assembly from evaporator.
5. Release the retaining tabs on thermistor assembly,
then pull thermistor out from the retainers.
To remove the evaporator thermistor:
4. Follow steps 1-3 above.
5. Pull thermistor from the tube located on the copper
tubing and remove from unit.
To remove the heat duct thermistor:
4. Follow steps 1-3 above.
5. Remove insulation from top of blower housing.
6. Pull thermistor assembly from top of blower housing
and remove from unit.
Blower Cover and Condenser Cover Removal
The blower cover and condenser cover have braces that
span the open area above the condenser fan and blower
assembly.
To remove the blower cover and condenser fan cover:
1. Disconnect power supply from unit.
2. Remove cabinet wrapper/sleeve.
3. Extract the screws securing the braces to the blower
and condenser covers. Remove braces from unit.
(See Figure 4-40)
4. Extract the screws securing the blower and
condenser covers to the unit. Lift covers off unit.
Top Scroll Cover and Duct Thermistor Removal
To remove the top scroll cover and duct thermistor:
1. Disconnect power supply from unit.
2. Remove cabinet wrapper/sleeve and control box
cover.
3. Remove braces and blower cover.
4. Disconnect duct thermistor wire leads from control
board. (See Figure 4-41)
5. Remove insulation covering thermistor wires. Pull
thermistor assembly from top scroll cover. The top
scroll cover may now be removed from the unit.
Figure 4-39.
Ambient
Thermistor
Evaporator
Thermistor
Figure 4-40.
Screws
Figure 4-41.
Duct Thermistor
Top Scroll Cover
Komentarze do niniejszej Instrukcji