Electrolux FAC124P1A Instrukcje Operacyjne Pobierz pdf (Strona 105)

Section 4 Component Teardown

4-45

Figure 4-117.

Bulkhead

Evaporator Thermistor Removal

To remove the evaporator thermistor:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

Remove the control panel from its installation

position but do not disconnect from wire harness.

3. Disconnect thermistor from control board.

4. Remove or cut any retaining straps. Remove

thermistor from retaining bracket. The retaining

bracket is pushed onto the evaporator tubing,

remove by pulling bracket out of evaporator.

(See Figure 4-115)

Control System Bulkhead Removal

The control system bulkhead provides a mounting

area for the electronic control and electrical system

components. Three screws secure the bulkhead to the

unit frame. Two of the screws will be removed as the

cabinet wrapper/sleeve and user interface are removed.

To remove the control system bulkhead:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

Remove control panel from its installation position.

3. Discharge capacitor. To discharge the high voltage

capacitor, wait for 60 seconds and then short-circuit

the connection of the high-voltage capacitor (that

is the connecting lead of the high-voltage rectifier)

against the chassis with an insulated screwdriver.

4. Disconnect all electrical leads from control board,

capacitor, power cord and anion generator. Remove

ground wires from bulkhead.

5. Pull wire harness through hole in bulkhead.

6. Extract screw from lower left side of unit frame. Pull

bulkhead from the unit. (See Figure 4-116)

Styrofoam Blower Compartment Removal

The styrofoam blower compartment consists of three

parts, with the top two pieces removable to access the

blower wheel. The top two pieces are taped together

and may be removed as an assembly.

To remove the styrofoam blower compartment:

1. Remove the front panel and cabinet wrapper/sleeve.

2. Cut the tape holding the top two styrofoam pieces to

the bottom section of styrofoam.

3. Lift the top two sections out as an assembly and

remove from the unit. (See Figure 4-117)

5th Pipe

4th Pipe

160cm

Clip On 4th Pipe

Top Section

Center

Section

Bottom

Section

Figure 4-115.

Figure 4-116.

Screw

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 139 140

Komentarze do niniejszej Instrukcji

Brak uwag

Electrolux FAC124P1A Instrukcje Operacyjne Strona 105

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Klimatyzatory typu split Electrolux FAC124P1A