Electrolux FAC124P1A Instrukcje Operacyjne Pobierz pdf (Strona 78)

Section 4 Component Teardown

4-18

Front Scroll Cover And Heater Assembly Removal

The heater assembly is mounted to the inside of the

front scroll cover. The front scroll cover is then mounted

to the evaporator assembly and to the front bulkhead

partition.

To remove the front scroll cover heater assembly:

1. Disconnect power supply from unit.

2. Remove cabinet wrapper/sleeve then remove control

box.

3. Remove the braces and blower cover, and the top

scroll cover.

4. Disconnect wire leads from control box leading to

the heater assembly.

5. Extract the 4 screws from each side of the

evaporator securing the front scroll cover to the

evaporator and front bulkhead partition.

(See Figure 4-42)

6. Carefully pull evaporator an inch away from the

front scroll cover to allow the front scroll cover to be

pulled from the unit base. Use caution not to kink or

rupture the sealed system tubing.

7. Pull front scroll cover with heater assembly from unit

base.

8. Lay the heater and front scroll cover on a flat

surface and extract the two screws securing the

heater assembly to the front scroll cover.

(See Figure 4-43)

9. Slide heater assembly to the left until the metal

legs are free of the retaining slots then pull heater

assembly off of front scroll cover.

Left Side

Right Side

Screws

If the thermal limiter and/or the thermostat are

defective, the entire heater assembly must be replaced.

NOTE

Figure 4-42.

Figure 4-43.

Screws

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 139 140

Brak uwag

Electrolux FAC124P1A Instrukcje Operacyjne Strona 78