Electrolux EQBH60AS Instrukcja Użytkownika Strona 18

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 17
18 options & operating instructions electrolux integrated bbq 600/300mm
Operating instructionsOptions for configuration of hotplates
and grills
Before lighting the barbecue:
Check that all hoses and gas ttings are tight.
Open the roasting hood or slimline lid.
NOTE:
The slimline lid is designed as a cover for weather protection.
The lid is not designed to be used as a cooking hood.
Check all control knobs are in the ‘OFF’ position.
Ensure that the cooking surfaces are clean.
Turn the gas isolation valve ‘ON’.
Lighting instructions
Do not attempt to light burners with cooking
surfaces covered.
Read instructions before lighting.
To light a burner, depress the knob and rotate to
‘HIGH HEAT’. A spark is generated to light the flame
thrower alongside the burner. The flame thrower makes
an audible noise and only operates when the knob is
depressed to light burner. Release the knob and check
if the burner is alight, note that the audible noise from
the flame thrower will stop when the knob is released.
If the burner did not light, turn the knob to the ‘OFF’ position.
Allow gas to disperse, then repeat lighting procedure.
Manual lighting
If, in the event of the automatic ignition system not
working, the barbecue can be lit manually.
To light manually, t a 40mm match to match holder
provided. Pass lit match through viewing slots below the
front of cooking plates down towards the burner, then
rotate the knob to HIGH HEAT to ignite. If ignition fails,
turn the control valve off and allow several minutes for
the gas to disperse before attempting to light again.
Once alight, repeat for other burners as required.
pass match holder
through viewing slot at
front under cooking plates
Preheating
This barbecue is tted with high power burners. In most
conditions it will only be necessary to preheat the barbecue
for 5 minutes before cooking can commence.
As with most things, experience will familiarise you with the
effectiveness of and the time required to achieve the desired
preheating time to obtain the desired cooking temperature.
Testing has shown that the burners can be turned
to low position for satisfactory cooking.
If the unit does not operate correctly refer to the
troubleshooting section on page 21.
For EQBH60AS & EQBL60AS the grills and hot plate can
be positioned as desired.
For roasting (EQBH60AS only) it is recommended to place
the hotplate in the middle and a grill plate each side.
warning
Ensure flame tamers are positioned under grill panels.
Alternative arrangement when not roasting
INTBBQ600/300_Jun11.indd 18 30/06/11 11:53 AM
Przeglądanie stron 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Komentarze do niniejszej Instrukcji

Brak uwag