Electrolux Electric Slide-In Range Instrukcja Naprawy Pobierz pdf (Strona 20)

2-8

Section 2 Installation Instructions

¾”

(1.9 cm)

¾”

(1.9 cm)

31½”

(81 cm)

Min.

Cutout

Width

Formed or tile countertop

trimmed ¾" (1.9 cm) back at

front corners of countertop

opening.

Figure 7

To eliminate the risk of burns or

ﬁre by reaching over heated surface units, do not have

cabinet storage space above the range. If there is cabinet

storage space above range, reduce risk by installing a

range hood that projects horizontally a minimum of 5"

(12.7 cm) beyond the bottom of the cabinet.

Countertop Preparation

•Thecooktopsidesoftherangetoverthecutout

edge of your countertop.

•Ifyouhaveasquare ﬁnish (ﬂat) countertop, no

countertop preparation is required. Cooktop sides lay

directly on edge of countertop.

•Formedfront-edgedcountertopsmust have molded

edge shaved ﬂat 3/4" (1.9 cm) from each front corner

of opening (Figure 7).

•Tilecountertops may need trim cut back 3/4"(1.9

cm) from each front corner and/or rounded edge

ﬂattened (Figure 7).

•Countertopmustbelevel. Place a level on the

countertop, first side to side, then front to back. If the

countertop is not level, the range will not be level. The

oven must be level for satisfactory baking results. Cooktop

sides of range ﬁt over edges of countertop opening.

4.1

4. Cabinet Construction

4.2

•Iftheexistingcutoutwidthisgreaterthan

30 1/16" (76,4 cm), reduce the ¾" (1.9 cm)

dimension.

Standard Installation

The range cooktop overlaps the countertop at the

sides and the range rests on the ﬂoor. The cooktop is

31½" (80 cm) wide.

Install base cabinets 30" (76.2 cm) apart. Make sure

they are plumb and level before attaching cooktop.

Shave raised countertop edge to clear 31½" (80 cm)

wide range top rim.

Install cabinet doors 31" (78.7 cm) min. apart so as

not to interfere with range door opening.

Cutout countertop exactly as shown on page 1.

Make sure the four leveling legs (front and rear) are

setup higher than the height of the cabinet (shown

on page 3).

Install the anti-tip bra ck et at

this point before placing the range at its final

position. Follow the installation instructions at the

last page or on the anti-tip bracket template supplied

with the range.

To provide an optimum installation, the top surface

of the countertop must be level and ﬂat (lie on the

same plane) around the 3 sides that are adjacent to

range cooktop. Proper adjustments to make the top

ﬂat should be made or gaps between the countertop

and the range cooktop may occur.

To reduce the risk of damaging your

appliance, do not handle or manipulate it by the

cooktop. Manipulate with care.

Position range in front of the cabinet opening.

Make sure that the underside of the cooktop clears

the countertop. If necessary, raise the unit by lowering

the leveling legs.

Level the range (see section 6). The floor where

the range is to be installed must be level. Follow the

instructions under "Leveling the Range".

Slide the range into the cutout opening.

IMPORTANT

If Accessories Needed :

Installation With Backguard

The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"

(56.2cm) Max.) needs to be increased to 24" (61 cm)

when installing a backguard.

Installation With End Panel

A End Panel kit can be ordered through a Service Center.

Installation With Side Panels

A Side Panels kit can be ordered through a Service

Center. Note: Install cabinet doors 32" (81.3 cm) min.

apart so as not to interfere with range door opening.

5. Range Installation

Important Note: Door removal is not a requirement for

installation of the range, but is an added convenience.

Refer to the Use and Care Guide for oven door removal

instructions.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 92 93

Komentarze do niniejszej Instrukcji

Brak uwag

Electrolux Electric Slide-In Range Instrukcja Naprawy Strona 20

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piekarniki Electrolux Electric Slide-In Range