
6 electrolux
Control knobs on the gas hob
The knobs for using the gas hob of the
cooker are found on the control panel. The
regulation knobs could be turned in anti-
clockwise direction until the small flame
symbol, and vice-versa for the larger symbol.
z No gas supply
Maximum gas supply
Minimum gas supply
To light a burner:
1. press the ignition switch marked by a small
spark (
);
2. push the relevant control knob in com-
pletely and turn it anticlockwise to the
maximum position (
);
3. upon ignition, keep the knob pushed
down for about 5 seconds. This will allow
the safety device ("thermocouple" - see
figure, letter D) to be heated and the
safety device to be switched off,
otherwise the gas supply would be
interrupted;
4. then, check the flame is regular and adjust
it as required.
If the burner does not ignite, turn the
control knob to zero, and try again.
If after a few attempts the burner does not
ignite, check that the burner cap and crown
(see figure, letter A, B) are correctly
positioned.
To interrupt the supply of gas, turn the knob
in a clockwise direction to the position "
z".
Do not keep the control knob pressed
for more than 15 seconds. If the
burner does not light even after 15
seconds, release the control knob,
turn it the “off” position and wait
for at least 1 minute before trying
to light the burner again.
))
))
)
A - Burner cap
B - Burner crown
C - Spark generator
D - Thermocouple
The gas burner controls
Komentarze do niniejszej Instrukcji