Electrolux EKK603504X Instrukcja Użytkownika Pobierz pdf (Strona 32)

32 electrolux

Electrical connection

The unit is preset to work with a voltage

of single phase 230 V.

Before making the connection make sure

that:

- the energy power available in the user's

house is sufficient for the normal supply

of this appliance (see rating plate).

- the unit is correctly connected to earth

through a suitable plug and according to

the installation country Laws.

- the socket or the omnipolar switch used

for the connection must be easilv reached

with the installed appliance.

The appliance is supplied with electric

cable, therefore you will have to fit it with a

standard plug, suitable for the total electric

load shown on the rating plate. The plug is

to be inserted into a suitable wall socket.

If you wish to directly connect to the

mains, you have to interpose an omnipolar

switch with a minimum opening between

flame is obtained.

• If changing from liquid gas to natural gas

20 mbar, undo the by-pass screw about

1/4 of a turn, until a small regular flame

is obtained.

• If changing from natural gas 20 mbar

to natural gas 13 mbar undo the by-

pass screw about 1/4 of a turn, until a

small regular flame is obtained.

• If changing from liquid gas to natural gas

13 mbar, undo the by-pass screw about

3/4 of a turn, until a small regular flame

is obtained.

Reassemble the parts following the same

procedure backwards.

Finally, check the flame does not go out

when quickly turning the knob from the

maximum position to the minimum position.

by-pass screw

contacts of 3 mm, between the unit and the

mains, complying with the existing

regulations.

The brown live wire (originating from the

clamp of the appliance junction box) must

always be connected to the phase of the

mains supply. In any case, the supply cord

must be positioned in such a way as it does

not reach in any point a temperature higher

by 50°C than the room temperature.

Replacement of the electric cable

The replacement of electric cable

must be carried out exclusively

by the service force centre or by

personnel with similar

competencies, in accordance

with the current regulations.

Should the supply cord need to be

replaced, use only the following cable types:

H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-

F, H05 V2V2-F (T90), H05 BB-F. It is

necessary that the yellow/green earth wire is

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Komentarze do niniejszej Instrukcji

Brak uwag