Electrolux EHD60020X Instrukcja Użytkownika Pobierz pdf (Strona 10)

glass surface at an acute angle and

move the blade on the surface .

– Remove after the appliance is suf-

ficiently cool: limescale rings , water

rings, fat stains, shiny metallic discol-

orations. Use a special cleaning agent

for glass ceramic or stainless steel.

2. Clean the appliance with a moist cloth

and some detergent.

3. At the end rub the appliance dry with

a clean cloth.

WHAT TO DO IF…

Problem Possible cause and remedy

You cannot start the appliance

or operate it.

• You touched 2 or more sensor fields at the same time. Only

touch one sensor field.

• There is water or fat stains on the control panel. Clean the con-

trol panel

•

The child safety device or key lock or

operates. See the

chapter Operating the appliance.

• Start the appliance again and set the heat setting in 10 seconds.

A sound operates when the ap-

pliance is off.

You covered one or more sensor fields. Uncover the sensor fields.

The residual heat indicator does

not come on.

The cooking zone is not hot because it operated only for a short

time. If the cooking zone is supposed to be hot, speak to the Af-

ter Sales Service.

Heat setting alternates The Power management is active. See the section Power man-

agement.

A sound operates and appliance

starts and stops again. After 5

seconds one more sound oper-

ates.

You covered . Uncover the sensor field.

comes on

• The automatic switch-off operates. Stop the appliance and

start it again.

Overheating protection for the cooking zone operates. Switch off

the cooking zone. Switch on the cooking zone again.

comes on

• No cookware on the cooking zone. Put cookware on the cook-

ing zone.

• Not correct cookware. Use the correct cookware.

• The diameter of the bottom of the cookware is too small for

the cooking zone. Move cookware to a smaller cooking zone.

and number come on.

There is an error in the appliance.

Disconnect the appliance from the electrical supply for some

time. Disconnect the fuse from the electrical system of the

house. Connect again. If

comes on again, speak to the after

sales service.

come on

There is an error in the appliance, because a cookware boils dry

or you use not correct cookware. Overheating protection for the

cooking zone operates. The automatic switch-off operates.

Switch off the appliance. Remove the hot cookware. After approx-

imately 30 seconds switch on the cooking zone again.

should disappear, residual heat indicator can stay. Cool down

the cookware and check it with the section Cookware for the in-

duction cooking zone.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the Customer Care Department. Give the da-

ta from the rating plate, three-digit-letter

code for the glass ceramic (it is in the cor-

10 electrolux

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Electrolux EHD60020X Instrukcja Użytkownika Strona 10

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Electrolux EHD60020X