Electrolux EKG6000A0X Instrukcja Użytkownika Pobierz pdf (Strona 23)

• it can not get hotter than room

temperature, higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp

edges or corners,

• it's conditions can be easily checked.

When checking the flexible pipe make

sure:

• it does not show cracks, cuts, marks

of burnings on the two ends and on its

full length,

• the material is not hardened, but

shows its correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

The gas supply ramp is on the rear side

of the control panel.

13.8 Levelling

CAUTION!

Remove all the accessories

from the oven.

1. Open the lid of the appliance and

disassemble it.

2. Disassemble the pan supports and

all the burner assemblies.

3. Put the appliance on the sidewall on

a clean and smooth surface. Place

each foot into a separate hole, in the

plinth, and rotate it clockwise.

B

4. If the floor is not equally flat, use the

adjustable feet on the bottom of the

appliance to set a stable position for

the appliance.

To install all the accessories, do the first

step in an opposite sequence.

13.9 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied with a main

cable and without a main plug.

WARNING!

The power cable must not

touch the part of the

appliance shaded in the

illustration.

ENGLISH 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Komentarze do niniejszej Instrukcji

Brak uwag