Electrolux EI30DD10KS Instrukcja Właściciela

Installation Instructions and Owner’s GuideTelescoping Downdraft Ventilation SystemsP/N 316902914 (June 2012)

10Cut Countertop Opening- Lay out and cut the cooktop cut-out far enough forward so downdraft will t behind it (refer to cooktop installation instruc

11Remove the Duct TransitionRemove the Duct Transition from the Chassis Housing by removing the two Phillips screws as shown and sliding the Duct Tran

12Remove Control Box CoverRemove the cover to the Control Box by removing the Phillips screw as shown and sliding the cover down. Remote Blower Wire C

13Install DuctworkInstall Cooktop- Align the cooktop with the downdraft and fasten cooktop in place.Connect Downdraft to Power- Plug the downdraft’s p

14InstallationCalculating Duct Length TableFor maximum efciency, use the shortest and straightest duct possible. The system will operate most efcien

15Operating the Telescoping Downdraft System- Raise the downdraft by pressing the raise/lower push button. The telescoping vent will rise up to full h

16Cleaning the Telescoping Downdraft VentCleaning the Telescoping Vent- Clean the stainless steel and plastic controls with a dishcloth and hot soapy

17Solutions to Common ProblemsQuestions or for service call: 1-877-4ELECTROLUX (1-877-435-3287)Before you callProblem SolutionTelescoping Vent does

18WarrantyYour appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replac

2Finding Information©2012 Electrolux Home Products, Inc. All rights reserved. Printed in U.S.A.Table of contentsThank you for choosing Electrolux, the

3TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:• Use this unit only in the manner intended by the manufactu

4TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:• Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers

5IMPORTANTRetain all packing and materials until the telescoping downdraft and all components have been installed.Tools You Will Need• Phillips Scre

6Model A B C D E RiseEI30DD10KS 30” (76.2 cm) 26 7/8” (68.3 cm)17 13/16” (45.2 cm)35 13/16” (91.0 cm)2 3/16 ” (5.5 cm)10” (25.4 cm)EI36DD10KS 36” (91.

7Maximum gap to cabinet back allowed before installation of a wood support is required for mounting stabilizing brackets9-5/8”(24.5 cm)CountertopCook

8Plan the DuctworkThis downdraft blower system is designed for use with 3¼ x 14” ductwork (can be transitioned to 8” or 10” round).For best performanc

9Plan the Electrical ConnectionThe downdraft blower system draws 4 AMPS and requires a 120 VAC, 60 Hz circuit.The unit has a 28 inch long power cord w