Electrolux GK58TSIO Instrukcja Użytkownika Pobierz pdf (Strona 12)

Problem Possible cause Remedy

and number comes on.

There is an error in the appli-

ance.

Disconnect the appliance from

the electrical supply for some

time. Disconnect the fuse from

the electrical system of the

house. Connect it again. If

comes on again, speak to the

service centre.

comes on

There is an error in the appli-

ance because a cookware boils

dry. The overheating protection

for the cooking zones and the

Automatic Switch Off operate.

Deactivate the appliance. Re-

move the hot cookware. After

approximately 30 seconds, ac-

tivate the cooking zone again. If

the cookware was the problem,

the error message goes out of

the display, but the residual

heat indicator can stay. Let the

cookware become sufficiently

cool and refer to “Cookware for

the induction cooking zone” to

see if your cookware is com-

patible with the appliance.

If you tried the above solutions and cannot

repair the problem, speak to your dealer or

the customer service. Give the data from

the rating plate, three digit letter code for

the glass ceramic (it is in the corner of the

glass surface) and an error message that

comes on.

Make sure, you operated the appliance cor-

rectly. If not the servicing by a customer

service technician or dealer will not be free

of charge, also during the warranty period.

The instructions about the customer service

and conditions of guarantee are in the guar-

antee booklet.

INSTALLATION

Warning! Refer to the Safety chapters.

Before the installation, note down

the serial number (Ser. Nr.) from the

rating plate.The rating plate of the

appliance is on its lower casing.

Modell GK58TSIO

Prod.Nr. 941 591 753 01

Typ 58 GAD D5 AU

220 – 240 V 50 – 60 Hz

Induction 7.4 kW

Made in Switzerland

Ser. Nr. ....................

7.4 kW

ELECTROLUX

Warning! During installation in

combustible matter, NIN SEV 1000 and

fire protection guidelines and

regulations of the Association of

Cantonal Fire Insurance shall be strictly

adhered to.

BUILT-IN APPLIANCES

• Only use the built-in appliances after you

assemble the appliance into correct built-

in units and work surfaces that align to

the standards.

CONNECTION CABLE

• The appliance is supplied with the con-

nection cable.

• Replace the damaged mains cable with a

special cable (type H05VV-F or higher).

Speak to your local Service Centre.

ELECTRICAL CONNECTION

• Install the appliance with a socket supply

line. If there is no socket supply line, the

fixed home electrical system must include

an isolating device with at least a 3 mm-

contact separation to enable a simultane-

12 electrolux

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag