Electrolux EHG60409X Instrukcja Użytkownika Pobierz pdf (Strona 13)

4.

With a thin screwdriver, adjust the by-

pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the ad-

justment screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the knob

from the maximum position to the

minimum position.

ELECTRICAL CONNECTION

• Ground the appliance according to safe-

ty precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the lo-

cal power supply.

• Any electrical component must be instal-

led or replaced by the Service Force

Centre technician or qualified service

personnel.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is an access to the

mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple connection (risk of fire). Check

that the ground connection is in con-

formity with the standard and regulations

force.

• Connect the appliance to the mains with

a device that lets to disconnect the ap-

pliance from the mains at all poles with a

contact opening width of minimum 3

mm, eg. automatic line protecting cut-

out, earth leakage trips or fuse.

• None of a parts of the connection cable

can not get a temperature 90°C. The

blue neutral cable must be connected to

the terminal block label with "N". The

brown (or black) phase cable (fitted in

the terminal block contact marked with

"L") must always be connected to the

live phase.

CONNECTION CABLE

Use only connection cable of type

H05V2V2-F T90 or equivalent type. Make

sure that the cable section is applicable to

the voltage and the working temperature.

The yellow/green earth wire must be ap-

proximately 2 cm longer than the brown (or

black) phase wire.

BUILDING IN

min.

55 mm

min.

650 mm

560 mm

480 mm

min.

450 mm

30 mm

10 mm

3 mm

11 mm

11 mm

A

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16

Komentarze do niniejszej Instrukcji

Brak uwag