Electrolux EHE64X Instrukcja Użytkownika Pobierz pdf (Strona 9)

Electrical connections

Any electrical work required to install this hob

should be carried out by a qualified electrician or

competent person, in accordance with the current

regulations.

THIS HOB MUST BE EARTHED

The manufacturer declines any liability should these

safety measures not be observed.

This hob is designed to be connected to a 230-240V

50Hz AC electrical supply.

The cable used (of the types: H05 V2V2-F T90, H05 BB-

F T90) must have a min. cross section of 1.5 mm².

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this book.

The hob is supplied without supply cord. A 3 core

flexible supply cord must be fitted.

1) Remove the mains terminal cover plate from

the underside of the hob, to expose the mains

terminal block.

2) Loosen the two cable clamp screws and lift

the top section of the clamp enough to allow

the cable to be passed through.

3) Connect the red (live) wire to the terminal

which is marked with the number 1.

4) Connect the black (neutral) wire to the

terminal which is marked with the number 4.

5) After fitting a green or yellow/green sleeve

over the bare copper wire (earth wire),

connect the exposed end to the terminal which

is marked with the earth symbol or with

the number 5.

The hob should be conncted to a double pole switch

with a minimum gap of 3 mm. between the switch

contacts and of a type suitable for the required load in

compliance with the current electric regulations. The

switch should be sited within 2m of the hob and be

easily accessible upon completion of the installation.

The switch must not break the yellow and green earth

cable at any point.

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

)

FO 0488

Wiring diagram

NOTE:

The earth wire should be about 2 cm. longer than

the live and neutral wires.

6) Secure the cable by means of the clamp screws

and refit the terminal block cover.

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Electrolux EHE64X Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Płyty grzewcze Electrolux EHE64X