Electrolux EPI09NLIWE Instrukcja Użytkownika Pobierz pdf (Strona 27)

26

The following checks prior to contact may save you time and money.

Water leakage

of indoor unit

The humidity is high.

Drain hose is loose or

obstructed.

Water leakage

of outdoor unit

During cooling operation, water

condensates around the pipes

and connection joints.

During defrosting operation,

During heating operation, water

on the heat exchanger drips out.

Noise from

indoor unit

The noise emmited when the fan

or compressor relay is switched

on or off.

When the defrosting operation

is started or stopped, there is a

the reverse direction.

Indoor unit can

not blow air

In HEAT mode, when the

temperature of indoor heat

stopped in order to prevent cold

air. (within 2 minutes)

In HEAT mode, when the

outdoor temperature is low or

humidity is high, frost will be

formed on the outdoor heat

exchanger. The unit will defrost

automatically and indoor unit will

During defrosting operation,

water or vapour may be

emmited.

In DEHUMIDIFY mode, the

indoor fan will stop blowing air

avoid condensing water being

vaporised again.

Moisture on air

outlet

If the unit operates at high

humidity for a long time, moisture

may be generated on air outlet

grill and then drip off.

The unit does

not operate

The unit does not operate if it is

turned on immediately after it is

turned off. This is to protect the

Odours are

emitted

Some odours may be emmited

from the indoor unit. This is the

result of room smells (such as

furniture, tobacco, etc.) which

have been taken into the unit.

Consult authorised service

center for cleaning if the odours

persist.

noise

The swishing noise like water

inside the unit.

Mist is

emmited in

COOL mode

During cooling operation, a thin

mist may be seen emmited from

the indoor unit due to high room

temperature and humidity.

After a period of time, the mist

will disappear as the decrease of

room temperature and humidity.

Cracking noise

This is the sound of friction

caused by expansion and/or

contraction of panel or other

parts due to the change of

temperature.

The unit can

not be started

up

Is the power cut off?

Is the power plug loose?

(if applicable)

Is the circuit protection device

tripped off?

Is voltage higher or lower?

(tested by professionals)

Is the TIMER correctly used?

Are the batteries exhausted?

Cooling

/Heating effect

is poor

Is the temperature setting

appropriate?

Is the air inlet/outlet blocked?

Is the door or window open?

Is low fan speed set?

Are there heat sources in the

room?

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 159 160

Komentarze do niniejszej Instrukcji

Brak uwag