Electrolux EKK6450AOX Instrukcja Użytkownika Pobierz pdf (Strona 30)

Minimum distances

Dimension mm

A 2

B 685

13.8 Gas connection

Use a fixed connections or use a flexible

stainless steel pipes in compliance with

the regulation in force. If you use flexible

metallic pipes, make sure they do not

come in touch with mobile parts and they

are not squeezed.

13.9 Flexible nonmetal pipes

connection

If you have an easy access to the

connection, you can use a flexible pipe.

The flexible pipe must be tightly attached

by clamps.

In installation always use the pipe holder

and the gasket. The flexible pipe can be

applied when:

• it can not get hotter than room

temperature, higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp

edges or corners,

• it's conditions can be easily checked.

When checking the flexible pipe make

sure:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length,

• the material is not hardened, but

shows its correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is complete,

make sure that the seal of

each pipe fitting does not

leak. To check the seal use a

soap solution, not a flame.

The gas supply ramp is on the rear side of

the control panel.

WARNING!

Before you connect the gas,

disconnect the appliance

from the electricity supply or

switch off the fuse in the fuse

box. Close the primary valve

of the gas supply.

13.10 Adjustment to different

types of gas

Let only an authorized person

do the adjustment to different

types of gas.

If the appliance is set for

natural gas you can change it

to liquid gas, with the correct

injectors.

The gas rate is adjusted to

suit.

WARNING!

Before you replace the

injectors, make sure that the

gas knobs are in the Off

position. Disconnect the

appliance from the electrical

supply. Let the appliance cool

down. There is a risk of injury.

The appliance is set to default

gas. To change the setting

always use the gasket

sealing.

www.electrolux.com30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Komentarze do niniejszej Instrukcji

Brak uwag