Electrolux EKG61103OX Instrukcja Użytkownika Pobierz pdf (Strona 9)

5. HOB - DAILY USE

WARNING!

Refer to Safety chapters.

5.1 Ignition of the hob burner

Always light the burner before

you put on the cookware.

WARNING!

Be very careful when you use

open fire in the kitchen

environment. The

manufacturer declines any

responsibility in case of the

flame misuse.

1. Push and hold the spark generator

button .

2. At the same time turn the knob for the

hob counterclockwise to the

maximum gas flow position

and

push it down to light the burner.

3. Release the spark generator button

when burner lights but keep the knob

on this position for equal or less than

10 seconds to let the thermocouple

warm up. If not, the gas supply will be

interrupted.

4. Adjust the flame after it is regular.

WARNING!

Do not keep the knob

pushed for more than 15

seconds. If the burner does

not light after 15 seconds,

release the knob, turn it into

the off position and try to light

the burner again after

minimum 1 minute.

If after some tries the burner

does not light, check if the

crown and its cap are in the

correct position.

In the absence of electricity

you can ignite the burner

without an electrical device.

In this case approach the

burner with a flame, push the

relevant knob down and turn

it to maximum position. Keep

the knob pushed for equal or

less than 10 seconds to let

the thermocouple warm up.

If the burner accidentally

goes out, turn the knob to the

off position and try to light the

burner again after minimum 1

minute.

The spark generator can start

automatically when you

switch on the mains, after

installation or a power cut. It

is normal.

5.2 Burner overview

A

B

D

C

A) Burner cap

B) Burner crown

C) Ignition candle

D) Thermocouple

5.3 Turning the burner off

To put the flame out, turn the knob to the

off position .

ENGLISH

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Komentarze do niniejszej Instrukcji

Brak uwag