Electrolux EGW7353NOX Instrukcja Użytkownika Pobierz pdf (Strona 12)

The rating plate is on the bottom of the

hob.

Model .......................................

PNC .........................................

Serial number ...........................

8.2 Gas Connection

WARNING!

The following instructions

about installation, connection

and maintenance must be

carried out by qualified

personnel in compliance with

standards and local

regulations in force.

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values. The

adjustable connection is fixed

to the comprehensive ramp

by means of a threaded nut

G 1/2". Screw the parts

without force, adjust the

connection in the necessary

direction and tighten

everything.

A B C

A) End of shaft with nut

B) Washer

C) Elbow (if needed)

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

"Flexible" connection with mechanical

end:

• Natural gas: connection carry out with

a flexible pipe with mechanical end

which is screwed directly on the elbow

finishing the slope of the appliance.

• Butane/Propane: use a flexible tube,

equipped with it's collars if it is worth

visiting over all it's length and if the

appliance runs only on butane. If the

appliance runs on Propane, use a

flexible pipe with suitable metal end.

Flexible nonmetal pipes connection:

If it is possible to easily control the

connection in its full area, you can use a

flexible pipe. Tightly attach the flexible pipe

by clamps.

Liquid gas

Use the rubber pipe holder for liquid gas.

Always engage the gasket. Then continue

with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length;

• the material is not hardened, but

shows its correct elasticity;

• the fastening clamps are not rusted;

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is complete,

make sure that the seal of

each pipe fitting is correct.

Use a soapy solution, not a

flame!

www.electrolux.com12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Komentarze do niniejszej Instrukcji

Brak uwag