Electrolux EWS126410W Instrukcja Użytkownika

EWS 126410 W... ...EN WASHING MACHINE USER MANUAL

SELECT THE REQUIRED PROGRAMMEBY TURNING THE PROGRAMMESELECTOR DIAL (1)Turn the programme selector dial to the re-quired programme. The washing machine

START THE PROGRAMME BYPRESSING BUTTON 8To start the selected programme, press thebutton 8, the green pilot light of the button8 stops blinking.To inte

AT THE END OF THE PROGRAMMEThe machine stops automatically. Threeblinking 0.00 appear on the display and thepilot light of button 8 goes off. Someacou

acetic acid; treat any residual marks onwhite fabrics with bleach and then rinsethoroughly.Tar stains: first treat with stain remover,methylated spiri

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSYNTHETICS60°

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartmentSOAK30°Prewas

ProgrammeMaximum and Minimum TemperatureCycle DescriptionMaximum Spin SpeedMaximum Fabrics LoadType of LaundryOptionsDetergentCompartment COTTONS ECO

CARE AND CLEANINGWarning! You must disconnect theappliance from the electricity supply,before you can carry out any cleaningor maintenance work.DESCAL

1. Remove any rust deposits on the drumwith a cleaning agent for stainless steel.2. Run a washing cycle without any wash-ing to clean off any cleaning

7. Remove fluff and objects from thepump.8. Make sure that the impeller of thepump can turn. If this does not occur,contact the service centre.9. Clea

Electrolux. Thinking of you.Share more of our thinking at www.electrolux.comCONTENTSSafety information 2Safety instructions 3Product description

6. press the two levers and pull forwardthe drainage duct to let the water flowout;7. when the container is full of water, putthe drainage duct back a

Problem Possible cause/SolutionThe machine does not fill:The water tap is closed. E10• Open the water tap.The inlet hose is squashed or kinked. E10• C

Problem Possible cause/SolutionSpinning starts late or themachine does not spin:The electronic unbalance detection device has cut in because thelaundr

Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approximateprogrammeduration (mi-nutes)Remainingmoisture(%)1)Cottons 40 °C 6 0.7

3. Unscrew the three bolts.4. Slide out the relevant plastic spacers.5. Open the porthole. Remove the poly-styrene block fitted on the door seal.Remov

2. Do not place the inlet hose downwards.Angle the hose to the left or right de-pending on the position of your watertap.3. Set the hose correctly by

collection point for the recycling of electricaland electronic equipment. By ensuring thisproduct is disposed of correctly, you willhelp prevent poten

electrolux 27

www.electrolux.com/shop 132949571-A-152013

• Obey the maximum load volume of 6 kg (refer to the “Pro-gramme chart” chapter).• If the supply cord is damaged, it must be replaced by themanufactur

• Before you connect the appliance to newpipes or pipes not used for a long time,let the water flow until it is clean.• The first time you use the app

DETERGENT DISPENSER DRAWER Compartment for detergent used forprewash and soak phase or for stain re-mover used during the stain action phase (ifavaila

Mount the rubber feet to prevent vibration,noises and displacement of the applianceduring operation.Read carefully the instructions supplied withthe k

extra quantity of water (extra rinse), selectthis option. Some additional rinses will beperformed. This option is recommended forpeople who are allerg

When the programme has finished threeflashing zeros are displayed, the pilot light9 and the pilot light of button 8 go outand the door can be opened.7

PERSONALISATIONACOUSTIC SIGNALSThe machine is provided with an acousticdevice, which sounds in the following ca-ses:• at the end of the cycle• if ther